Warning: mkdir(): No space left on device in /www/wwwroot/T3.COM/func.php on line 127

Warning: file_put_contents(./cachefile_yuan/ibaolong.com/cache/4f/fad47/1dbfc.html): failed to open stream: No such file or directory in /www/wwwroot/T3.COM/func.php on line 115
日皮软件免费火炬前端要不要加增壓風機,如何選型_公司日皮免费观看视频_日皮免费观看视频資訊-山東日皮视频免费環保能源設備有限公司






    日皮视频免费,日皮软件免费,日皮免费观看视频,男女日皮免费视频

    歡迎進入山東日皮视频免费環保能源設備有限公司

    熱線電話

    0531-69953988

    分類導航
    產品展示
    聯係日皮视频免费
    山東日皮视频免费環保能源設備有限公司

    聯係電話:18678860671

    服務熱線:0531-69953988

    聯係地址:中國(山東)試驗區濟南片區孫村街道經十東路33688號章錦綜合保稅區聯東U穀科創中心5號樓 101

    日皮软件免费火炬前端要不要加增壓風機,如何選型

    當日皮软件免费壓力不滿足用氣要求時,應設置日皮软件免费專用增壓機。日皮软件免费火炬的壓力為1.5~2.0kpa,

    When the pressure of biogas does not meet the gas requirements, a dedicated biogas booster should be installed. The combustion pressure of biogas torch is 1.5-2.0 kPa,

    那麽當日皮软件免费壓力不滿足火炬壓力時就需要加增壓機;

    So when the biogas pressure does not meet the torch combustion pressure, a booster needs to be added;

    垃圾填埋場日皮软件免费火炬,需要加增壓機;

    The biogas combustion torch at the landfill site requires the addition of a booster compressor;

    有小夥伴又會問了,需要用哪種增壓機呢?

    Some friends may ask again, which type of turbocharger do you need?

    base64_image

    羅茨鼓風機和離心鼓風機是日皮软件免费工程中常用的增壓設備;

    Roots blower and centrifugal blower are commonly used boosting equipment in biogas engineering;

    羅茨鼓風機屬於恒流風機,工作的主要參數是流量,輸出壓力隨管道和負載的變化而變化,流量變化很小。

    Roots blower belongs to constant flow fan, and its main working parameter is flow rate. The output pressure varies with the changes in pipeline and load, and the flow rate changes very little.

    如果負載需要恒壓效果,則使用離心風機,因為離心風機屬於恒壓風機。工作的主要參數是風壓。輸出流量隨管道和負載的變化而變化,壓力變化不大。當多台鼓風機並聯運行時,由於並聯影響,流量減少。一般來說,兩台羅茨鼓風機並聯時的流量損失約為10%,兩台離心鼓風機並聯時的流量損失則大於10%。

    If the load requires constant pressure effect, a centrifugal fan should be used because centrifugal fans belong to constant pressure fans. The main parameter of work is wind pressure. The output flow rate varies with changes in the pipeline and load, while the pressure does not change significantly. When multiple blowers run in parallel, the flow rate decreases due to the parallel effect. Generally speaking, the flow loss when two Roots blowers are connected in parallel is about 10%, while the flow loss when two centrifugal blowers are connected in parallel is greater than 10%.

    可以根據現場的實際工況來選擇哦。

    You can choose according to the actual working conditions on site.

    增壓機選型要注意以下幾點:

    When selecting a turbocharger, the following points should be noted:

    1、增壓機流量按用戶小時最大用氣量確定,壓力按用戶需要的最高壓力和增壓機出口至用戶之間的最大阻力之和確定;

    1. The flow rate of the turbocharger is determined based on the maximum hourly gas consumption of the user, and the pressure is determined based on the maximum pressure required by the user and the sum of the maximum resistance between the turbocharger outlet and the user;

    2、最好買兩台增壓機組,一用一備;

    2. It is best to buy two booster units, one for use and one for backup;

    3、各增壓係統應設置止回閥,阻火器,回流管道,自動切斷閥,壓力變送器等;

    3. Each boosting system should be equipped with check valves, flame arresters, return pipes, automatic shut-off valves, pressure transmitters, etc;

    本文由日皮软件免费脫硫提供幫助,更多的相關內容請點擊:http://www.ibaolong.com希望本文能夠為您帶來幫助,感謝您的閱讀!

    This article provides assistance with biogas desulfurization. For more related content, please click: http://www.ibaolong.com I hope this article can be helpful to you. Thank you for reading!

    相關產品 日皮视频免费的存在,是為了更好的服務於日皮软件免费等可燃氣體淨化及利用行業
    網站地圖